This procedure is intended to make the installation of broadsize cannon in wooden tall ship kits as enjoyable as possible.
DSC02989.JPG DSC02990.JPG DSC02978.JPGDSC02983.JPGDSC02984.JPGDSC02985.JPG
Previous pageNext page Parts to be used...
Parts to be used...  ·  We will end up with this small wood part installed behind the port edges and with the cannon glued into a hole we will drill after gluing the wooden part in. We wait until the piece is installed and the glue has cured before drilling the hole for the cannon stud, because we want to drill at slightly different angles depending upon where in the hull the port is located.
Procedure by Don M. Evans http://www.lazuli.com